Thanks Brad, I will check into getting that done...
VLAD
96 Indy "FASRAM"
www.IndyRam.org
-----Original Message-----
From: owner-dakota-truck@buffnet4.buffnet.net
[mailto:owner-dakota-truck@buffnet4.buffnet.net]On Behalf Of
N2mopars@aol.com
Sent: Monday, December 21, 1998 8:30 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: Re:Intake Manifold Attn. VLAD
In a message dated 98-12-21 00:22:29 EST, you write:
<< I wonder how much clearance I would have by welding another plate on.
The
one thats on it appears to be fairly thin... What exactely did you have in
mind Brad.
Thanks >>
If you lay the original plate flat, imagine another plate "floating" over it
about 1/4". Take the long sides of the floating plate, and bend 1/4" down
on
both sides to 90 degrees so they touch the original plate. Weld them on,
leaving the short ends open. This will act as a heat shield from the hot
oil.
Brad
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:11:29 EDT