There is a heavy wire/rod on the door handle, that goes to
the release mech. On the release mech, it is held by a
plastic clip that rotates around the top of the wire, latching
it in place. Twist the clip loose, and the wire rod comes off.
reverse to re-install.
The install sheet from Crutchfield has photos and better directions
than I can give. The rear is fun too, you have to buy a big torex
wrench to pull the shoulder seat belt loose to get the side trim off.
Yuch.
Mike '98 CC
-- "Thoughtcrime was not a thing that could be concealed forever. You might dodge sucessfully for a while, even for years, but sooner or later they were bound to get you." - George Orwell, Nineteen Eighty-Four
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:11:50 EDT