In a message dated 1/22/99 2:41:50 PM EST, ashort@flash.net writes:
<< Hello all, went to the dyno this A.M. to make a pull on my '98 R/T.
Fortunately, Eric (swede) used the same dyno a few months ago on his '99
R/T. Eric's stock baseline #'s were: 190.5 hp
/ 248.9 ft. lbs.
My R/T with mods: 272.0 hp / 280.6 ft. lbs.
Better than I would have guessed, my mods are: JET II chip, 180 Stat,
Elec Fans, MP Headers/y-pipe, ported throttle body. Impressive as it may
sound, it isn't a lot faster than stock. >>
Is the torque figure above correct, mine was around 345 lb. ft., if I remember
correctly with 241 hp. I have only the JET II, 180 stat, and TB.
Steve Waller in Houston
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:11 EDT