O26ON4@aol.com wrote:
>
> In a message dated 1/22/99 2:41:50 PM EST, ashort@flash.net writes:
>
> << Hello all, went to the dyno this A.M. to make a pull on my '98 R/T.
> Fortunately, Eric (swede) used the same dyno a few months ago on his '99
> R/T. Eric's stock baseline #'s were: 190.5 hp
> / 248.9 ft. lbs.
> My R/T with mods: 272.0 hp / 280.6 ft. lbs.
> Better than I would have guessed, my mods are: JET II chip, 180 Stat,
> Elec Fans, MP Headers/y-pipe, ported throttle body. Impressive as it may
> sound, it isn't a lot faster than stock. >>
>
> Is the torque figure above correct, mine was around 345 lb. ft., if I remember
> correctly with 241 hp. I have only the JET II, 180 stat, and TB.
> Steve Waller in Houston
Well, as usual on the dml, you can't perform the same task and get the
same result. Results seem to be as individual as the people who perform
them. Thes are the #'s I have. I may try another pull some day.Alan S.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:12 EDT