If you don't a vise, try bringing it to your local garage... I've found that
many of these places are happy to help out for a minimal charge (sometimes
no charge)
Gary Shook
>In a message dated 99-01-23 20:50:40 EST, you write:
>
><< I don't think its threaded. I am looking at the picture in the factory
> service manual; the picture of the tube shows the end as unthreaded with
an
> O-ring on it. On my AutoZone replacement pump, The hole is a smooth bore
> with a chamfered edge. When I was using vicegrips, I was trying to
> 'unscrew' it, but it wouldnt move. Any other ideas? >>
>
>Mucho heat
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:14 EDT