RE: RE: MTX Thunderform

From: Jason Jennings (jason@spray-tech.com)
Date: Mon Jan 25 1999 - 17:10:40 EST


I have done a full all out separation from the coil.... The rest was
intact, the coil was toasted bad. Yeah, there ya go. that is what I
was reaching for.... Yes, I always check my THD ratings.... I never
knew the full name, but I knew it was a percentage of distortion at a
certain output power. Yeah, the more you twist that gain on the amp
(amp, radio, any outputting unit in the circuit) the closer you are
getting to a dirty signal (distorting it...). I suppose as long as you
control your gains and stay away from the distortion at the top of the
gain.... You won't have problems with your speakers..... In the Ram
the speakers were always over qualified for the stock radio, just in
case....

Jason
1/25/99 5:10 PM

        -----Original Message-----
        From: David Gloff [SMTP:dgloff@xnet.com]
        Sent: Monday, January 25, 1999 3:26 PM
        To: 'dakota-truck@buffnet.net'
        Subject: Re: DML: RE: MTX Thunderform

>> I always shop knowing my RMS and MAX values. The
        first thing I do is make sure my total peak/max power driven to
my
        speakers is less than the RMS of the speaker itself. I have
blown
        several speakers (MTX was the first set, hahahahaha) not paying
        attention to that amp.

        While it is possible to blow speakers from too much power
(actually
        tearing the cone from the spider), it's extremely difficult.
However,
        it's way too easy to blow speakers from too much distortion.
Distortion
        is measured in % of THD (Total Harmonic Distortion) at a
particular
        wattage output. Lower is better, preferably .1% or lower. When
shopping,
        I TRY (but don't always succeed) to get an amplifier that equals
or
        slightly exceeds the power rating of my speakers (both in RMS,
of course),
        with very low distortion. If you go lower than the rated output
of your
        speakers (assuming a quality amp), just make sure you don't have
to turn
        up the amp too far. If gain must be set above about 5/8 or 3/4
to get
        sufficient output, you have an underpowered amp. The closer you
get to
        the top of the gain knob, the more distortion. The very best
systems run
        with the gain at the lowest setting (turned counter-clockwise
all the
        way). Mine doesn't, because I'm cheap (it's around 1/2 of
maximum). My
        two indian-heads.

        David Gloff
        Computer Technician
        Valcom Professional Computer Center; Kemper/Scudder/Zurich Funds
        aolim: dgloff
        Loaded Intense Blue '99 Dakota Sport CC 318 5-speed 3.92SG
        Sony C680 CD Player and HX-504 amp
        Phoenix Gold XS 10" Sub, 6 1/2" midranges, 3/4" tweeters



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:14 EDT