where did you get the Edelbrock's at that price? Cheapest I've seen is
385.00
-----Original Message-----
From: Mark Kuzia <flyboy01@worldnet.att.net>
To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
Date: Monday, March 08, 1999 11:49 PM
Subject: DML: Re: Re: Re: J.B.A. vs EDELBROCK--headers
>$305 w/ Y-pipe. (+$3.00 for gas)
>
>Mark
>
>-----Original Message-----
>From: Jason&Sarah <Jpm699@email.msn.com>
>To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
>Date: Monday, March 08, 1999 10:54 PM
>Subject: DML: Re: Re: J.B.A. vs EDELBROCK--headers
>
>
>>I believe I got the JBA's with a ceramic coating and shipped for about
>$400.
>>What were the Edelbrocks?
>>
>>Jason
>>
>>
>>
>>
>>>I chose the Edelbrocks, they are not bad, it only took 3 1/2 hours to
>>>install. The JBA's are better made, but they are twice the money as the
>>>Edelbrock. Mine gave me a 20 hp increase as measured with a G-tech. I
have
>>>yet to run any 1/4 mile times, too much snow and salt (no traction).
>>>
>>>I have done a write up on them on my page http://home.att.net/~flyboy01
>>>
>>>Mark
>>>
>>>-----Original Message-----
>>>From: Mst29@aol.com <Mst29@aol.com>
>>>To: DML <dakota-truck@buffnet.net>
>>>Date: Monday, March 08, 1999 6:35 PM
>>>Subject: DML: J.B.A. vs EDELBROCK--headers
>>>
>>>
>>>>you more power? which are made better? does anybody have dyno results? i
>>>gotta
>>>>decide between the two.if more, how much more? thanx for any help.
>>>>
>>>
>>>
>>
>>
>>
>>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:06 EDT