I will be getting a new air intake for my '93 Dak. I am not gonna pay $100
for the FIPK, but I am going to buy a generic 10" or 14" air intake
thing(which is better?)
Blake
'93 LE Silver/White
4x2 Auto
5.2L 318cu V-8
-----Original Message-----
From: Bob H <torch@triplet.net>
To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
Date: Thursday, March 25, 1999 5:11 AM
Subject: Re: DML: K&N Filters
>At 08:40 PM 3/24/99 EST, you wrote:
>>I installed a K&N open element cone filter on my '97 4x4 V8. You can use
K&N
>>#RE-0930. I used a piece of exhaust pipe with a 90 degree bend to connect
the
>>filter to the convoluted rubber coming off the intake hat. Go to your
local
>>autoparts store and tell them you need Walker pipe # 41003. This pipe is a
3"
>>inlet, 3" outlet. The smaller end will fit inside the filter and the
larger
>>end will fit the convoluted hose. You will need to make up a couple on
mount
>>brackets and have them welded to the pipe to hold it in place. This setup
>will
>>put the filter in about the same location as the original filter box. I
>had to
>>cut off about 2" of the small end and about 3/4" of the large end to
locate
>>the unit where it didn't rub anything. If interested I could get some
>pictures
>>and e-mail them to anybody that would like to see this setup. Mike
>>
>>Mike,
>
>I would like to see it, thanks.
>
>
>Take care,
>
>Bob
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:21 EDT