> I put together a
> lowering block how-to and mentioned So Low as a steel block alternative to
> AIM's Extruded aluminum ones (although I haven't had any problems with the
> aluminum ones) and wanted to see if So Low's were pinion angle correct.
> Thanks
> Charles Smith
> 99 Dak R/T
-------------------
Charles, Sorry for the delay (digest mode).
I don't think they have adjusted the 2" square steel tubing for pinion
angle. I think it IS required for 2 inches or more, yet I had no
vibration
at all with these blocks. The custom solid steel blocks are 1 1/2 inches
and to my knowledge does not require a pinion angle adjustmet. I will
say
when I removed the So Low Susp. blocks (I didn't do the install) I
noticed
the centering pin was about a 1/4 inch to long. Any install with these
blocks
may need to trim the centering pin for a snug fit. I like Lance Martz
idea of
bolting the solid steel ones to the leaf springs.
GS -
98 5.2L 5spd
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:24 EDT