Got it... ;)
I've personally had great success with the MSD 6T and would recommend it to
anyone that asks. You'll be very happy with it. (Just don't expect BIG
horsepower gains.....Jus kiddin')
> In a message dated 99-05-09 20:48:53 EDT, you write:
>
> << Ok...I'm kind of skeptical about BIG horsepower gains from just an
ignition
> coil. Kyle, what condition were your old plugs, wires, and coil in
before
> you changed them? (Sounds like you noticed gains from a Tune-Up.) Don't
> take it the wrong way...i've also been looking for a coil that'll fit
where
> the old one is. (I like the MSD Blaster-SS...but can't put it in the
> original location.)
> >>
>
> I was kidding about feeling a huge gain when putting in the new wires,
coil,
> and plugs. Dont get me wrong, it was a noticable gain, but nothing drastic
> like you mentioned about being skeptical about huge gains from ignition
mods.
> However, I was extremely pleased with the tune up and the gains I got fom
it.
> This was my first experience with MSD wires(8.5 Super Conductors) and I
was
> extremely happy with them. When I did the parts swap, my truck had about
> 100,000 miles on it. The only ignition 'mod' was a Borg Warner Select
brass
> cap and rotor, more of an uprgrade than a mod. I did notice a nice more
> smooth throttle acceleration and better mileage after putting on the new
> coil, wires, and plugs. The plugs that I replaced were 45,000 mile old
> Champion Truck Plugs, I replaced them with the same kind.
> I hope the MSD 6-Offroad ignition will cap off all my ignition mods;
coming
> this week just in time for some pre season(deer) scouting!
> Kyle
> 93 Dakota 4x4 V6
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:13:59 EDT