John,
My '96 is OBD-II. The IAT mesures: Hot approx. 2.64K Cold approx. 14.15K
Rich - Ashburn, VA
-----Original Message-----
From: Jon Smith [mailto:jdsmith4@yahoo.com]
Sent: Thursday, June 17, 1999 10:47 AM
To: dakota-truck@buffnet.net
Subject: DML: IAT sensor: 2kohm?????
I forget who first posted saying they were using a 2k
ohm resistor, Mark K. maybe?? Anyway, I've checked my
IAT sensor at various temps w/ an ohmmeter, 2k ohm is
the reading after driving over 100miles.... So this
would tend to make a cold motor run real lean. Has
anyone else measured their IAT resistence? I'm
curious to know if perhaps OBD II will use a different
set of IAT resistence values than my OBD I.
===
Jon Smith -- Raleigh, NC
'95 CC SLT 4x4 318 auto (15.653@89.12)
MP comp, JBA headers, 8.5mm MSD wires, 14x3 FABM & SBBS, dual cat-back
glasspacks, 180 degree thermo, spectre wire dividers, ASP underdrive crank
pulley, Hayden 16" elec. fan
http://come.to/killbilly
ICQ # 9720504
IM: Fast4x4
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:25 EDT