Re: won't start

From: KURTZ ERIC (erics5.9@home.com)
Date: Mon Jul 05 1999 - 08:45:47 EDT


Is that the flywheel sensor? I cant remember where that wire went
Eric

mh wrote:
>
> I changed out the clutch and throw out bearing today and now my truck won't
> start. The starter whips it around just fine but it doesn't even try to
> catch. I am guessing I damaged the electrical wiring. When I first remated
> the bell housing to the block I mashed the three wire cable that runs into
> the bell housing. I assume this is the pickup coil. The cable was flattened
> but not cut or crimped so I was not suspecting it but would like to check
> it out. Anyone know how it should ohm out? I wouldn't think there would be
> anything in the harness to the transmission that should inhibit the
> ignition. Suggestions appreciated.
>
> doc



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:14:48 EDT