It's a 1/4" (Coarse Thread) Pipe Plug. Any hardware store should carry
them. (The plug I used was an extra Oil Drain PLug from my Go-Kart engine.)
-----Original Message-----
From: owner-dakota-truck@buffnet4.buffnet.net
[mailto:owner-dakota-truck@buffnet4.buffnet.net]On Behalf Of
Dester223@aol.com
Sent: Tuesday, August 10, 1999 2:05 AM
To: dakota-truck@buffnet.net
Subject: Re: DML: IAT Sensor relocated with success!!
Bernd. I looked at the IAT sensor tonite and i see that it's VERY do-able.
What size nut did you use? for the cap, and how did you thread the IAT into
the intake tube? my setup seems to be exactly like yours. I'll have
pictures of everything and i hope you can put it on your site (internet
retard here)
-DEster
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:15:42 EDT