First, a simple question, does the outside edge of the butterflies have to
sit flush/ against the bore ot the TB? Like does a 'seal' have to be there,
or can a gap exist?
Secondly, does anyone out there who works on modifying TBs(QuickD , R&D, B&F,
whomever) sell just any aftermarket parts for TBs? I am interested in a few
things, trying to do some simple and cheap mods to my throttle body. I would
first be interested in some type of tricked out butterflies/throttle plates.
These can be made of anything, I just need them to be thinner than the stock
plates and these also have to be the stock size; the fit into the stock bore
size.
Also, I am looking for a stainless steel(or any other material really)
butterfly shaft, as long as it is thinner than the stock shaft for increase
airflow. I like how some of you guys out there have a very slim design with
ther butterflies/shaft, along with the screws being almost sunk into the
butterflies/plates. I would even like some screws included, if possible.
Last, is some type of S-bolt, since I will only be doing a few minor homebrew
porting job(clean up the bores, not lower than the plates, and remove the
tall ridges on top of the TB, and try to create a 'slope' or 'taper' at the
top of the bores), I would like this s-bolt to top things off. Let me know, I
would appreciate it. Thanks for any info along with pricing. Maybe you guys
can start producing a stock upgraded butterfly/shaft/s-bolt kit where you
could just make em and send them out, no cores or anything else to deal
with!! Thanks agian.
Kyle
93 Dakota 4x4 V6
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:15:42 EDT