S-bolts are really easy to make, you would probably be better off just going
to a hardware store and bending one yourself. Unless you're concerned about
the strength issue. Wasn't there someguy on here that bent his own s-bolt
and it broke off into his motor? Hope that doesnt happen to me...
Will
In a message dated 8/10/99 3:32:33 PM, GrnDak4x4@aol.com writes:
>
>Last, is some type of S-bolt, since I will only be doing a few minor homebrew
>porting job(clean up the bores, not lower than the plates, and remove the
>tall ridges on top of the TB, and try to create a 'slope' or 'taper' at
>the top of the bores), I would like this s-bolt to top things off. Let me
know,
>I would appreciate it. Thanks for any info along with pricing. Maybe you
>guys can start producing a stock upgraded butterfly/shaft/s-bolt kit where
you
>could just make em and send them out, no cores or anything else to deal
>with!! Thanks agian.
>Kyle
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:15:42 EDT