ok, i'll work on getting one. thanks.
> -----Original Message-----
> From: Bernd D. Ratsch [SMTP:bernd@texas.net]
> Sent: Tuesday, August 17, 1999 7:50 PM
> To: dakota-truck@buffnet.net
> Subject: DML: RE: RE: K&N Gen-II and eRam Setup
>
> As long as there is an intake opening (or tube), it's not a problem. You
> can mount it after the stock airbox on the tube, or fab your own intake
> system. Now I can't speak for the '94 in particular, but if you have a
> picture of your intake system, i'd be happy to find out for you what would
> work best.
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@buffnet4.buffnet.net
> [mailto:owner-dakota-truck@buffnet4.buffnet.net]On Behalf Of Mooberry, J
> Sent: Tuesday, August 17, 1999 5:06 PM
> To: 'dakota-truck@buffnet.net'
> Subject: DML: RE: K&N Gen-II and eRam Setup
>
>
> sounds wonderful. anybody know how you'd set up the eRam on a '94?
>
> > -----Original Message-----
> > From: Bernd D. Ratsch [SMTP:bernd@texas.net]
> > Sent: Monday, August 16, 1999 11:18 PM
> > To: dakota-truck@buffnet.net
> > Subject: DML: K&N Gen-II and eRam Setup
> >
> >
> > Ok...three words:
> >
> > OH MY GOD!!
> >
> > This setup is the sh-t. I mounted/grafted a Super eRam to the front of
> a
> > K&N Gen-II for my Dak and it is an awesome combination. The
> better/cooler
> > air charge from the K&N combined with the boost from the eRam is
> > definitely
> > the was to go on our V6's. The only thing that had to be modified was
> the
> > removal of 5" from the K&N Tube and a adapter for the 3" eRam to the 4"
> > tube. Otherwise, the install was a snap. As for that heat shield that
> > K&N
> > delivers with the kit, that thing is a pain in the a$$ to install on a
> V6.
> > I know, not designed for the V6...but i'll be taking my time on the
> > re-fabrication to allow it to fit a little better. (It's off for now.)
> >
> > Anyway...The "Butt Dyno" feels the improvement, the speedo shows the
> > faster
> > acceleration, and the G-Tech tests will be run tomorrow.
> >
> > Pictures will be on the site in a few minutes.
> >
> >
> >
> > Bernd D. Ratsch
> > Pflugerville, TX
> > 1997 Dodge Dakota SLT/CC - 2WD
> > http://lonestar.texas.net/~bernd/Dakota.htm
> > bernd@texas.net
> > ICQ: 39320084
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:15:52 EDT