okay, what is the cheapest way to pull codes for a 99 5.2?
----- Original Message -----
From: Jon Steiger <stei0302@cs.fredonia.edu>
To: <dakota-truck@buffnet.net>
Sent: Monday, September 13, 1999 6:49 PM
Subject: Re: DML: OBD-II Scanner Software attn Jon
>
>
> On Mon, 13 Sep 1999, Eric Kurtz wrote:
>
> > Under windows, there are a few programs useful in the Dak like
> > > my OBD-II scanner software, and also Delorme Streets USA which I
> > > use in conjunction with a GPS.
> >
> > Jon,
> > I got that little snip from the off list, but I figure this is Dak
> > related!! What type and where did you get your software? Are you
> > capable of doing mods with this!?!?!?!?!?!
>
> Unfortunately, no. Its "read only". It gives you the sensor
> readouts and such, and allows you to read the DTCs. There are a
> couple of different ways to view the outputs like graph, etc. But
> you can't actually change the timing or anything like that. Its
> helpful to get a bit more info about what the engine is doing
> though.
>
> The one I use is the "personal" version of the Ease scan tool.
> Its about $300
>
> http://www.easesim.com/
>
>
> -Jon-
>
> .--- stei0302@cs.fredonia.edu ----------------------------------------.
> | Jon Steiger * AOPA, DoD, EAA, MP Race Team, NMA, SPA, USUA * RP-SEL |
> | '96 Dodge Dakota V8, '96 Suzuki Intruder 1400, '96 Kolb FireFly 447 |
> `--------------------------- http://www.cs.fredonia.edu/~stei0302/ ---'
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:16:47 EDT