Man...Can't I play Pokeman?
Unclip the connector, remove the screw (single screw holding speedo-gear),
pull out speedo gear, replace speedo-gear, reinstall (make sure the rubber
o-ring is seated properly), put screw back in, put the connector back
on...STOMP HARD ON THE GAS. ;)
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet4.buffnet.net
[mailto:owner-dakota-truck@buffnet4.buffnet.net]On Behalf Of
Dester223@aol.com
Sent: Tuesday, September 14, 1999 10:31 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: RE: Speedo Gear change location.
All the way near the back of the tranny? like a lil 3 plug sensor going
from
it? Hey! i can do that. Can you give me some procedures.
-Dester
<< If it's a 5spd...it's on the tailshaft (driver's side). If it's an
automatic ('98-higher) there is none. If it's a '97 auto, then it's on the
tailshaft.
- Bernd >>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:16:47 EDT