No. Pikachu is MINE! hehe.
Anyways, just so i don't go pulling wrong sensors. We are talking about a 97
dakota v6 auto with the 42RE tranny... and the sensor/gear is on the end of
the tranny where it goes out and attaches to Mr. Driveshaft? Also. by doing
this, does that correct your odometer and all that other stuff?
-Dester
<<
Man...Can't I play Pokeman?
Unclip the connector, remove the screw (single screw holding speedo-gear),
pull out speedo gear, replace speedo-gear, reinstall (make sure the rubber
o-ring is seated properly), put screw back in, put the connector back
on...STOMP HARD ON THE GAS. ;) >>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:16:47 EDT