In a message dated 9/23/1999 4:23:42 PM Pacific Daylight Time,
bernd@texas.net writes:
<< The special bores that MP sells have a 1/4" overbore (.250!!) as in their
SUPERBORE 250 and 260 - unheard of - and it has several special designs
that are "patent pending". His have no bottom end bog as some of the
others do because he uses a stock shaft, which is very strong, and which
also accurately preserves the OE TPI voltage ranges off the potentiometer,
according to Jules. >>
The TPI voltage has been thoroughly discussed with various design engineers
at DChrysler as well as in the aftermarket. They do not back the above
"theory"...Then again, you dont have to teach science in Kansas either these
days...Must see Dyno sheets...now if it was the MAP he was talking about...
Id like to see that design with a .250 over-board!
Bruce
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:17:09 EDT