On Tue, 2 Nov 1999 DRD892@aol.com wrote:
[...]
> Problems: Use a 180 degree thermostat. It does not like a hot engine.
> Use 93 octane fuel to control pre-ignition.
> The unit will turn on the "check engine" light. Why, I don't know yet.
> I have sent a e:mail to Hypertech asking this question but got no reply
> yet. I have plugged in the stock computer to pull the codes but there were
> no codes to pull. You can reset the "check engine" light by disconnecting
> the negative side of the battery for a minute or so. Buy the light will
> eventually
> come back on again. The truck runs great with the light off or on. It makes
> no
> difference.
David,
Can you pull the codes with the Hypertech still attached?
-Jon-
.--- stei0302@cs.fredonia.edu ----------------------------------------.
| Jon Steiger * AOPA, DoD, EAA, MP Race Team, NMA, SPA, USUA * RP-SEL |
| '96 Dodge Dakota V8, '96 Suzuki Intruder 1400, '96 Kolb FireFly 447 |
`--------------------------- http://www.cs.fredonia.edu/~stei0302/ ---'
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:19:02 EDT