You could tell the difference? Worse...Better??
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
To: dakota-truck@buffnet.net
Subject: DML: RE: IAT Sensor Mod
>Actually, I plugged a resistor into the IAT harness without the >hassle of
>removing the sensor. You can find a table of ohm values >and corresponding
>temps in the service manual. I used a 15k ohm >resistor to show a constant
>~ 50 degrees F at all times. Never got >any codes, and mileage hasn't
>changed a bit. Seemed to pick up >better at low speeds.
I tried to tell them that but they insisted on buying a new sensor and
relocating it and everything. I took it out after a hundred miles or so, and
I had to put it right back in. I could tell a difference.
later
gordon
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:19:07 EDT