In a message dated 11/13/1999 2:14:11 AM !!!First Boot!!!,
rugbynut@ameritech.net writes:
<< I used a dremel with the cutting bit. It takes forever, and my poor
little cordless dremel kept over-heating. It probably didn't help
that it was over 100 degrees that day, and the bumper was so damn hot
anyways that it kept fusing back together once the dremel cut it.
Ryan Grimes >>
you could always get a hole saw that is the circumference of the hole you
wanna cut. Just find the center and drill it out. than take a file and smooth
out where the saw cut.
Rob
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:19:11 EDT