> I want to put a sub behind each seat in my regular cab.
> http://www.jlaudio.com/enclosures/prowedge/index.html
> Anyways i measured and it looks like it would fit accept for the depth. I want my seat to
> maintain full range of motion and it comes up a little less that an inch and a half to
> short. I noticed when measuring that the back wall of the truck (just under the window)
> isn't flat. It has to humps on each side of the middle "seat". The hump is about half an
> inch out. My question is can that back covering with the hump be replaced with a flat
> piece or is there stuff behind it that would prevent a flat piece from working? Also what
> is behind there is there anything or just the metal of the cab? There is just metal behind
> the carpeted insulating panel. I mounted a 10" sub in a slope front box behind the drivers
> seat and I cut arround the box with a sharp knife and removed the insulation where the box
> recessed into it. That saved about an inch and as long as I dont remove the box it looks
> good.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:19:17 EDT