In a message dated 11/21/99 9:31:16 PM Mountain Standard Time,
SS454454@aol.com writes:
> dude someone is pulling your D**C. I never heard of a lowering job warping
> the brakes. how did you lower it? depending on the lowering you did on
the
> rear the driveshaft angle could be off. As for the warping id go and get
> rotors put them on with some fresh pads and break them in. the reason
rotors
>
> waro is if you do high soeed slow downs and the rotors get hot a lot. Or
if
> they get hot and you run warte from a hose or drive through warte.
> If youre in so cal ill help you do the brakes. forget the midas idiots.
> Rob
I dunno, My older bro had a 93 Club CabLong Bed 318 Dakota, he warped his
front rotors with just regular driving, He seemed to think there were
underdesigned for the load of the big ass truck, reguardless of lowering, it
wouldn't wrap rotors, that's BullSh*t... Greg
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:19:22 EDT