Wait a minute. I didn't say you should go over them lightly with sandpaper.
That would do about... nothing.
I meant having them turned about 4 thousands of an inch on a brake lathe...
That is what "should" be done (recommended by auto manufacturers) but on my
new rotors, I just slapped them on and put the pads on.
-Dester
<< Also I was hoping I wouldnt have to turn
them, as I did with the new rear drums, you can just go over them lightly
with some sandpaper in a circular motion, just wasnt sure if the same can be
done with rotors. No need to turn new drums. hopefully I wont have to with
the rotors.
Kyle
93 Dakota 4x4 V6 >>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:35 EDT