In a message dated 04/07/2000 6:10:59 PM Central Daylight Time,
IRONWILL30@aol.com writes:
<<
i'm putting a holley 1850 (600cfm vac sec) on my 79 furd f-150 w/ 302,
anbody
tell me how to adjust this thing, what screws do what ect. thanks Paul
Finley
94 dak cc 4x4 V6 5spd,
>>
You should have 2 little screws on the side of th fuel metering block,right
behind the front fuel bowl. Get yourself a vacum guage and adjust these idle
screws until you receive the highest vacum reading. In leans out the mixture,
out richens it up.
Also make sure to check you're fuel bowl level so it does'nt lean out at
W.O.T,
there should be a brass plug screwed into the side of the fuel bowl, with the
engine running take this plug out and check the level if it's correct you'll
have a small amount of gas trickleing out of the hole if its to low unlock
the nut on the top middle of the fuel bowl and adjust the screw till you get
the trickle if it's to high adjust the screw back until you get a trickle
you'll probably have to play with it a bit but when you get it set you
should'nt have to mess with it again. Good Luck.
MrDakota 95
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:38 EDT