Aren't you supposed to run the engine at 1500 RPMS for about 5 hours under
that "engine treatment" stuff, then change the oil, drive it for about 5,000
miles and you're ready to go? That's what I think it is. Should be
somewhere close to that...
-Dester
<<
What is the best starting procedure for a fresh motor. Its a 79 furd 302,
just installed a re-ring kit and 4bbl intake and carb. The carb is a holley
1850 600cfm vac.sec. Also where do i set the screws on the carb so i can
break in the cam and should i try to adjust the carb during cam break in?
Thanks for any help
Paul Finley
>>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:38 EDT