How much did it cost to have them coated?
__________________________________________________________
Tim Berry -- Chesapeake, VA
ŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻ
----- Original Message -----
From: "Clay Cooke" <cooke@ecn.purdue.edu>
To: <dakota-truck@BUFFNET.NET>
Sent: Thursday, April 13, 2000 9:43 Dark
Subject: Re: DML: Edelbrock Headers installed!!
>
> Yup!! Ive got em on my Ram, and they are GREAT headers!! Especially for
> the money, with a y-pipe... there is only one problem with them, they
> might be stainless steel, but they will rust, a friends of mine are pretty
> rusty looking. Edelbrock headers are made of 409 stainless, which doesnt
> have enough nickel (if any) to be resistant to rust. Thats why I got mine
> Jet-hot coated. Just a note on something to watch out for.
>
> Clay
>
> 84 Dodge Ram, scrapin pavement w/ 440 8bbl
> 96 Indy Ram, scrapin EVERYTHING w/ 360 Magnum!' -(www.indyram.org)
> 69 Road Runner 440 6bbl, project car
>
> http://expert.cc.purdue.edu/~cooke
>
> On Thu, 13 Apr 2000, Tim Berry wrote:
>
> > Welp, its time to update sig file again =-)
> > Got the headers/Y pipe installed in about 2.5 hrs... only hard part was
> > gettin the new bolts that are behind the pips in tight (2 on each side)
and
> > everything else fit like a glove...
> > only bloodied 2 fingers... (enough to make wrenches slippery =)
> > I must say tho.. its much better sounding with the cut out off... =-) i
> > also tryed punching it @ 25MPH (hits 1st gear) and in the rearview i
could
> > see faint black marks about 10' long each tire =-) these are some nice
> > headers for the price (only had them a few hrs tho) but I like them =-)
> >
> > Pics will go up later (when I take them)
> > __________________________________________________________
> > Tim Berry -- Chesapeake, VA
> > `97 SLT 318 auto CC 2x4 LSD:
> > Dual's w/Flowmaster, Homemade K&N GEN II, 2 Electric Fans
> > 180 T-stat, MSD 8.5 wires, Traction Bars, F&B Stage 1, Mod'd intake
> > ASP Pullies (Crank/Alt), Trans Go Shift Kit, BFG 275/60's, MP Puter
> > Edelbrock Headers/Y-pipe, Exhaust cutout B4 cat
> > BEST 1/4 15.488 @ 86.23 MPH
> > ŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻ
> >
> >
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:44 EDT