If you have the Mopar (Leach) headers, you'll probably have to drop the Y
pipe. Any 7/8" open end should work fine.
Kelly
In a message dated 4/23/00 7:51:31 PM Eastern Daylight Time,
k85go76@erols.com writes:
> Thanks Kelly! I'm also thinking I may need a special wrench for this. I
> have to reach around the header collector as it is on top of it pointing
> upward. There's not much clearance..it's quite a tight spot and it doesn't
> appear that I can go at it from above through the engine compartment. Any
> further suggestions for tools here?
> Thanks again!
>
> Bob King
> Pennsville, NJ
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:53 EDT