Mine are the Doug Thorley's . I was thinking a "crow's foot" open end piece
on a 3/8"drive ratchet extension with a couple "U" joints for flexibility
might get it done.??
Thanks again!
Bob King
Pennsville, NJ
-----Original Message-----
From: Mag318Racr@aol.com <Mag318Racr@aol.com>
To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
Date: Sunday, April 23, 2000 7:57 PM
Subject: Re: DML: Torque specs for '95 Oxygen Sensor
>If you have the Mopar (Leach) headers, you'll probably have to drop the Y
>pipe. Any 7/8" open end should work fine.
>
>Kelly
>
>
>In a message dated 4/23/00 7:51:31 PM Eastern Daylight Time,
>k85go76@erols.com writes:
>
>> Thanks Kelly! I'm also thinking I may need a special wrench for this.
I
>> have to reach around the header collector as it is on top of it pointing
>> upward. There's not much clearance..it's quite a tight spot and it
doesn't
>> appear that I can go at it from above through the engine compartment.
Any
>> further suggestions for tools here?
>> Thanks again!
>>
>> Bob King
>> Pennsville, NJ
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:53 EDT