22MM open end / box end
__________________________________________________________
Tim Berry -- Chesapeake, VA
`97 SLT 318 auto CC 2x4 LSD:
Dual's w/Flowmaster, Homemade K&N GEN II, 2 Electric Fans
180 T-stat, MSD 8.5 wires, Traction Bars, F&B Stage 1, Mod'd intake
ASP Pullies (Crank/Alt), Trans Go Shift Kit, BFG 275/60's, MP Puter
Edelbrock Headers/Y-pipe, Exhaust cutout B4 cat
BEST 1/4 15.488 @ 86.23 MPH
ŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻ
----- Original Message -----
From: "Bob King" <k85go76@erols.com>
To: <dakota-truck@buffnet.net>
Sent: Sunday, April 23, 2000 7:46 Dark
Subject: Re: DML: Torque specs for '95 Oxygen Sensor
> Thanks Kelly! I'm also thinking I may need a special wrench for this. I
> have to reach around the header collector as it is on top of it pointing
> upward. There's not much clearance..it's quite a tight spot and it
doesn't
> appear that I can go at it from above through the engine compartment. Any
> further suggestions for tools here?
> Thanks again!
>
> Bob King
> Pennsville, NJ
> -----Original Message-----
> From: Mag318Racr@aol.com <Mag318Racr@aol.com>
> To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
> Date: Sunday, April 23, 2000 1:59 PM
> Subject: Re: DML: Torque specs for '95 Oxygen Sensor
>
>
> >Bob, I'd just make sure that the crush gasket is fully sealed when
torquing
> >it. Also you might want to clean up the threads before and use some
extra
> >anti-seize on it.
> >
> >
> >---------------------------------------------
> >Kelly in SC
> >'96 CC 5.2
> >'92 Daytona IROC R/T Finally!
> >'86 Daytona Turbo Z CS "Free 2 Good Home"
> >
> >In a message dated 4/23/00 12:53:58 PM Eastern Daylight Time,
> >k85go76@erols.com writes:
> >
> >>
> >> I'm changing out my crappy Borg-Warner O2 sesnor for the Bosch type I
> had
> >> originally. I noticed they have a torques spec of 20 ft-lb for this
> >sensor.
> >> Is this torque spec crucial? Don't want to spend the time and screw
> things
> >> up.
> >>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:53 EDT