Oh, ok. That is what is in the gen II's. Really I don't know then what the
genIII's have. I just figured that they didn't change the setup through the
years but I guess they did. Thanks for the correction.
Chapell
-----Original Message-----
From: Tim J Koth [mailto:Tim.J.Koth@aexp.com]
Sent: Wednesday, August 02, 2000 12:27 PM
To: dakota-truck%buffnet.net
Subject: DML: RE: Re: Locking Hubs
I can tell you right now the 2000 model does not have a center disconnect
for
the front axle. There is no vacuum module on it, and I had the whole front
jacked up and turned the tires and the front driveshaft and everything
turns.
The only disconnect on the 2000 is in the transfer case. It's my
understanding
that the front axle in the 2000 is a little different than what was put in
on
the previous gen III's, but I don't know what the difference is. Maybe
someone out there knows?
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:53:14 EDT