OK...what year was your truck again?
The .040" was mentioned as a medium between the factory '97-Up (factory
.040" gap) and '96-Older (factory .035" gap). I'm running .045" on my truck
as well as two of my co-workers are running .045" on theirs as well..with
3923's...and only two of us have an MSD system. The third one is completely
stock on his 5.9.
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
To: dakota-truck@buffnet.net
Subject: DML: RE: RE: Another Autolite question.
> If you're not running anything other than the stock coil: .040"
>
> - Bernd
OK, I wasn't going to bring this up until the first tank o' gas results were
in, but since we're on the subject.... I threw in the 3923's yesterday
gapped at .045 as per a previous recommendation (I won't mention Bernd's
name here ;-) ), and I swear the truck felt slighty more rough than it did
prior -- but I thought that might just be my imagination. Should I pull 'em
out and regap to .040 until I get the MSD 6A?
Thanx,
- Alex
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:53:17 EDT