That's mike d selling those.. If they are the 1.7s, he bought them from me.
They should include the pushrods too, as that's what I sold him. Email
him for the exact setup. IF he isn't selling the pushrods, you can get
them from crower for $60-70 I believe...atleast under $100 I know.
Installation takes about 3-4 hours.
Sam '00 RT
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> [mailto:owner-dakota-truck@buffnet.net]On Behalf Of
> Fast4x4Dakota@aol.com
> Sent: Sunday, October 22, 2000 6:57 PM
> To: dakota-truck@buffnet.net
> Subject: Re: DML: RE: Roller Rocker installation tips?
>
>
> I don't know if they're self alligning, I assume not since the seller is
> advertising Rockers, Guideplates and studs as a package. My truck is rev
> limited to 5200 rpm so the RPM isn't an issue right now. I think
> if I did
> install the Crowers I'd get the new pushrods and use the
> guideplates, better
> safe than sorry.
>
>
> Luke
> 1996 Black 4x4 Dakota, SLT CC SB, 318, 3" 2 Chamber Flowmaster cat back
> exhaust, 9" open element Mr. Gasket Air cleaner, A-500 3.55
> geared Peg Leg 8
> 1/4, 31 10.50 BFG Mud Terrains, Alpine CD player, Infinity Kappa
> Speakers.
> Coming soon: E-Body 8 3/4" Rear axle, 3.55 gears, Detroit locker,
> 10" Brakes,
> and Moser Engineering custom alloy axles!
>
> > Do the rockers have small stainless washers on each side of the roller
> > tips??? If so, you can use the rockers (self aligning) without the
> > guide plates, and use stock push rods. This setup is good to 5500 rpm.
> > If you do not have the self aligning tips (no washers on either side
> > of the roller tip), you'll need the guide plates. The stock push rods
> > should be okay, but again you are limited to 5500 rpm with that 'half'
> > of the installation. Call Crower to confirm the setup to get the real
> > scoop.
> >
> > Sam
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:56:19 EDT