What is the process of putting the headers on?
-------------------------------------------
Steven St.Laurent
Test Engineer
Test Branch, GSD, MCTSSA
MARCORSYSCOM, USMC
760-725-2506 (DSN 365-2506)
Work:mailto:stlaurents@mctssa.usmc.mil
Home:mailto:saint1958@home.com
-----Original Message-----
From: xjruss@excite.com [mailto:xjruss@excite.com]
Sent: Monday, November 06, 2000 8:21 AM
To: dakota-truck-digest@buffnet4.buffnet.net
Subject: DML: RE:Re:Gibson Headers
Jake,
I did not have any problem like what you are describing. It was not
that hard to get the driver side in, just navigate around the hoses and
wires. But the passenger side was actually easier (after I removed the
fender well. I would recommend having a friend to help. Job took about 4-5
hours total.
-Russ
-Original Message-
Did you have any problems getting them in on the drivers side? I tried to
put on a set of FLOWTECH and there was no way they were going in on the
drivers side because of the power brake module behind the master-cylinder. I
think I'm gonna try Gibson out since the store owes me a free set. hehehe
JAKE
_______________________________________________________
Say Bye to Slow Internet!
http://www.home.com/xinbox/signup.html
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:06 EDT