Which ignition coil did you replace it with, stock, MSD or Accel ?
-----Original Message-----
From: ABeerCan@aol.com <ABeerCan@aol.com>
To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
Date: Thursday, November 16, 2000 4:14 PM
Subject: DML: Finally figured out the 97 Dak problems
>Well, after lots of head scratching, butt scratching, and a few other types
>of scratchings we finally figured out my friends problems. We tested his
>tps, map, camshaft sensor, crankshaft sensor, and everything else we could
>take off and test. We finally tested the ignition coil and the primary
side
>ohm reading was fine when it was cold, but if we cranked it up and let it
>stumble a few times, and check the resistance it was almost zilch. So we
>scratched a little more, figured that all the sensor testing was a good
>excuse for the beer drinking, and put a new coil on it. Fired up perfect
the
>first try!! I think it is kinda cool that the comp could tell the primary
>side was going out!
>
>96 Paxton huffed 408 Dakota
>Look out Lightnings! Here comes a MOPAR!!!
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:25 EDT