Email Totally Polished or go to there website www.totallypolished.com. I
would leave the Body Drops to the pros. There is a lot of cutting and
fabricating to do. The bed floor needs to be raised and I am not sure about
the front.
Good Luck,
Steven
http://www.smokindakota.com
http://www.dodge-trucks.net
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Scott E. Stinson
Sent: Monday, November 27, 2000 4:44 PM
To: Dakota Mailing List
Subject: DML: Project 1 LoDako
DML:
Has anyone ever performed a BODY DROP? I can do the suspension etc, myself,
but looking at Mike D's Project, I think I want my body lower than the frame
will allow it to go. Can I just use a cutting wheel, and remove the cab
mounts? What about the bed box, and the front clip? I am serious, so I would
appreciate serious responses, such as the ones from Mike.
LOL!!!
Any Ideas how I can get my non-daily driver as low as possible, yet retain
some decent camber?
Mike D, if I were to use the Lower control arms and spindle combo, where
would my scrub line be sitting on 17" rims, and some 40 series Z rubbers?
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:40 EDT