At 03:21 PM 12/18/00, you wrote:
>If it's only around 50 to install.....must be a pretty simple install. Any
>idea of what's involved? Thanks!--Aaron--
1. Disconnect -ive battery cable.
2. Drain coolant from rad and block.
3. Thoroughly clean block core hole and block heater seat (plug
should be next to the oil filter on the rad side).
4. Insert block heater assembly with element loop pointing down.
5. With block heater fully seated, tighten center screw to
17 in. lbs. of torque.
6. Using clips, run cord from pass. side, across top of rad., to
driver's side.
7. Fill cooling system.
8. Reconnect -ive battery cable.
9. Start and warm engine checking for leaks.
Hope this helps.
Bob. Burlington, Ont., Canada.
'97 Dakota CC, 5.2L, 4x2, 3.92 SG, auto., 4265 lb.
Dyno: 231.2 rwhp 340.0 lb-ft rw torque
PB: 14.737 @ 91.75 9.364 @ 72.95
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:58:02 EDT