Good luck at the dyno Tim let us know how ya did!?!?!
----- Original Message -----
From: "Tim Berry" <coolva1@home.com>
To: <dakota-truck@buffnet.net>
Sent: Saturday, January 27, 2001 10:53 PM
Subject: DML: Re: RE: MAP/IAT Boxes out in the field - Preliminary results
> I found that running at 50k ohm on my setup or colder (higher resistance)
> for long periods of time will cause an MIL code of 52 (running too rich,
> detected because the computer is constantly leaning mixture) or sumthin
> close to that... (thats because I have 24# injectors as well I'm sure)
>
> But I can tell a difference from about 50% throttle to the floor instead
of
> watching my A/F meter fall off the scale on lean about 75% throttle, is
> stays in the normal range and the speedometer just climbs and climbs....
> (before it'd just be soo lean that the motor would just sound bogged and
not
> do anything untill ya floored it)
>
> Hittin the Dyno tomorrow... Whoooo!! :)
> *-=-=-=-=-=-=-=-=-=-=-=-=-*
> Tim Berry (97 Dakota Club Cab)
> Chesapeake, VA
> Best 1/4: 13.50@101.91
> *-=-=-=-=-=-=-=-=-=-=-=-=-*
> > -Tim Berry: Has the box and installed - Preliminary report...Had to
> readjust
> > -the FMU to an 8:1 plate (from a 12:1...running too rich under boost).
> Also
> > -improved his shift points...don't know if this is an after effect or
just
> a
> > -coincidence. Runs much stronger.
> > -- Bernd
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:58:44 EDT