Sounds okay to me. No extra loads, you're just changing the time when the
lamps turn on. I doubt the difference between low beam and high beam make
enough difference to cause any problems....unless those aren't stock
headlights.
Ron
00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
For modifications see my DML Profile (URL follows)
http://www.twistedbits.net/WWWProfile/dakota/Kw9pV1EkFeOYY
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of John_Neff@Dell.com
Sent: Tuesday, February 20, 2001 9:36 AM
To: dakota-truck@buffnet.net
Subject: Re: DML:(ATT: John) Fog lights on with high beams
BINGO!!!
That's the one I was looking for.
For those of you with a little more electrical knowledge than what I posses.
Does this all sound straight? I'm curious what kinds of loads are placed on
the wiring harness when this mod is performed.
John
>FOG LAMPS ON WITH HIGH BEAMS
>This is a fairly simple, 5 minute procedure. First, you must remove the
>black plastic dash frame. It just snaps out. Then, remove the 3 screws
>holding the headlight switch in and remove the switch. There are 2
>connectors on the back of the switch.. A 2-wire connector and a multi-wire
>connector. The 2 wire connector has a BLACK and a BLACK with GREEN STRIPE
>wire. Run a jumper from the BLACK with GREEN STRIPE wire in the 2 wire
>connector to the LIGHT BLUE with BLACK stripe wire on the multi-wire
>connector. That's it! Your fog lights will come on when you turn them on
>(parking lamps must be on, at least) and will stay on with low or high
>beams.
>http://users.jnlk.com/dakrt/foglamps.htm
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:59:21 EDT