Bernd,
Is the IAT sensor input to the computer used much during closed loop? You
mentioned before that your map box "helped" someone's tranny behavior, any
more insight on that matter?
Patrick Delgado
> From: "Bernd D. Ratsch" <bernd@texas.net>
> Reply-To: dakota-truck@buffnet.net
> Date: Wed, 21 Mar 2001 23:12:40 -0600
> To: dakota-truck@buffnet.net
> Subject: RE: DML: IAT box & dyno results
>
>
> (1) It simply taps into the existing IAT sensor harness (two wires need to
> be cut near the sensor connector...very easy installation). The factory IAT
> sensor is located on the passenger-side front of the Intake Manifold (big
> brass looking "thingy"). IAT (or AIT) is the Intake Air Sensor (been on
> vehicles since 1980's).
>
> (2) Since the IAT is actually just a thermistor, the box allows you to vary
> the temperature setting to the PCM by simply turning a dial. Factory temp
> readings range from 160-210 degrees. Best performance is colder than that.
>
> It works on Supercharged, Normally Aspirated, Race or Daily drivers.
>
> - Bernd
>
> --
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:22 EDT