yep ron, new taylor wires, the plugs are six months old , and the rotor is a
little older than the plugs..:)
----- Original Message -----
From: "Ronald Wong" <ron-wong@home.com>
To: <dakota-truck@buffnet.net>
Sent: Saturday, March 24, 2001 3:15 PM
Subject: DML: RE: RE: Installed the MSD
> Hmmm...is that the same "Zing" you threw at me yesterday?! ;-)
>
> Anyway, Paul, people usually put in a fresh set of plugs, cap, and rotor,
> and perhaps a new set of wires. Those things will definitely help the
> "zing".
>
> Ron
> 00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
> For modifications see my DML Profile (URL follows)
> http://www.twistedbits.net/WWWProfile/dakota/Kw9pV1EkFeOYY
>
>
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Bernd D. Ratsch
> Sent: Saturday, March 24, 2001 1:06 PM
> To: dakota-truck@buffnet.net
> Subject: DML: RE: Installed the MSD
>
>
> Give it a little bit, but the "zing" should be there...a little bit. Try
to
> notice the idle quality, acceleration (smoother or not?) and MPG in the
long
> term.
>
> - Bernd
>
> -----Original Message-----
> From: owner-dakota-truck@buffnet.net
> [mailto:owner-dakota-truck@buffnet.net]On Behalf Of Paul Bumann
> Sent: Friday, March 23, 2001 2:53 PM
> To: DML
> Subject: DML: Installed the MSD
>
>
> Well i put the MSD in , wired the factory coil into it.
>
> Ok, now where is the ziiing at? It ran pretty much like normal, no Check
> engine light or anything yet. Too early to tell yet?
> Any other MSD stories or advice?
> I put in the 6A box.
>
> Paul
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:25 EDT