In a message dated 4/25/01 8:12:22 AM Eastern Daylight Time,
hoegen@kersur.net writes:
<<
I hope the new badges have the adhesive on them?? Originally I planned to
use 3M two sided tape...but it's alot thicker then the stock adhesive. >>
Oh, you are replacing them with new ones? Yes the new badges have the 3M
adhesive already on them, i'ts easy as can be to put them on, just line up
the holes and snap youre done. I would suggest after install, running a few
strips of masking tape or something over them to help the glue get a better
grip. Leave the tape on as long as you can but it should just take a few
hours and you will be fine.
Good luck.
Zeus
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:11 EDT