Here's a question for everyone.
I am debating several items as the next modification for my baby.
1) Crower Roller Rockers and new Push Rods for over 5500RPM use. Won't get
over 5500RPM's till I get a new cam so I was thinking of these first.
2) New Cam and Roller Timing Chain tuned for my setup that's listed below.
3) 4.10 Gears for both the front and rear diff's. I currently have 3.5's and
could really use the lower launch these would provide.
4) This is a bit out of my range right now but R/T heads, ported and
polished.
I'm thinking of going with the gears for now as that will give me the most
butt bang for the buck at the moment I think. I was thinking of saving up
and doing the Heads, Roller Timing Chain, M-1 Manifold, and Cam all in one
big swoop. I'd probably have a shop do that work, as I would be worried of
screwing it up.
Based on the mods I have what would be you guy's suggestions???
Thanks,
Shawn
98 5.2L 4x4 CC
Powerdyne 9PSI Supercharger
200 LPH Fuel Pump
50mm Flow Metrics TB
JBA Silver Ceramic Headers w/SS y pipe
Gibson Dual Catback
24# Ford Motor Sports Injectors
Black Magic Electric Fan (ditched the Clutch Fan)
180T-Stat
Autolite 3923's
IAT Adjuster with A/F Meter
Leach Custom PCM
MSD6BTM
MSD SS Coil
MSD 8.5mm Wires
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:44 EDT