Nope....7-8mm only.
- Bernd
-----Original Message-----
From: owner-dakota-truck@BUFFNET.NET
[mailto:owner-dakota-truck@BUFFNET.NET] On Behalf Of Andy Levy
Sent: Friday, July 20, 2001 2:05 PM
To: dakota-truck-moderator@bent.twistedbits.net
Subject: Re: DML: Wire Looms - Spectre
Will they fit fatter wires (8.5-10mm)?
"Bernd D. Ratsch" wrote:
> Well, the post about the wire looms got me thinkin' about what else
> may fit that's readily available.
>
> Spectre P/N# 4596 works very well on a V6 and V8. It comes with four
> CHROME stand-off's with BLUE wire looms (RED also available but don't
> have the P/N# handy).
>
> Since you normally route the wires behind the rear of the valve
> covers, there's enough slack to run them across the top of the valve
> covers (moving the wires away from your manifolds or headers). You
> can use your factory bolts/studs for those with the factory valve
> covers or replace them with either a stud kit (also at PepBoys) or
> bolts to clean things up a bit.
>
> Cost: about $10 at PepBoys
>
> - Bernd
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:10 EDT