In a message dated 10/23/01 11:54:27 AM Eastern Daylight Time, acg302@ptd.net
writes:
> The engine i'm putting into my dak is out of a 97 1/2 ton van, And i think
> the oil pan is different, but i'm not sure. Will I be able to use this oil
> pan when the engine migrates off of the stand and under the hood of my '92
> dak. or will i have to find a different oil pan? And as for my feul rails
> problem. what do i do about that, The engine i aquired has the single feul
> line into the side of the drivers side feul rail, but the V6 has a 2 feul
> line system with the pressure regulator built into the rails. How do i
> overcome this obstacle? I have no idea how the system for the van works or
> how i could adapt it the the one in my truck. any advice would be much
> appreciated
> -Aaron G
>
>
>
>
>
>
Look at the pans and see if they are the same. Front sump vs.rear sump.
If they are not you will need to swap them. Sorry, I can't help with the fuel
question.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:21 EDT