Uhhhh...i'll stick to the tried and true method of cleaning up the
flywheel. Take .002" off to clean it up and give it a good crosshatch
pattern.
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net] On Behalf Of greg conner
Sent: Tuesday, October 23, 2001 11:12 PM
To: dakota-truck@buffnet.net
Subject: RE: DML: Re: RE: Clutch Replacement Questions?
lol..no..the manuel says that the flywheel is hardened and machining it
will
ruin its integrity, if there are hot spots or craks they want ytou to
replacee it..I'll get there exact wording tomorrow
Greg Conner
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:21 EDT