They are just fine, I would put some gasket sealant on both sides of the new
gasket just for extra measure.
J
-----Original Message-----
From: owner-dakota-truck@BUFFNET.NET
[mailto:owner-dakota-truck@BUFFNET.NET]On Behalf Of jay & dana
Sent: Sunday, January 20, 2002 4:17 PM
To: DML
Subject: DML: Tstat bolts
When replacing these bolts after a new gasket should you use anti-seize or a
thread locker or are they fine just as is if torqued properly?
TIA
~Jay
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:49 EDT