Cool, also ..there are honest people out there but just in few.
----- Original Message -----
From: <B1LLYW@aol.com>
To: <dirt@4x4wire.com>
Cc: <dakota-truck@buffnet.net>
Sent: Thursday, January 24, 2002 7:09 PM
Subject: DML: Got My 4.56 Gears Installed
> Let me start by saying that if you think 4.56 gears are too much for 33"
> tires, I believe you should reconsider. It rocks!
>
> I picked my truck up tonight from the shop that installed my gears. I had
> never used them before but they seem to have done a good job. Roth
> Automotive in New Britain, CT. It cost me $500 labor front and rear to
> install the gears, which was $250-$400 less than any other quote I got.
And
> Roth came well recommended to me from two different sources.
>
> I'm not getting any noise I can hear from the gears.
> The throttle response is amazing. It's like you are always in the power
> band. And it's not a sudden kick in the ass, like with the blower. You
hit
> the gas, and you are right there. Even getting on the highway and
cruising
> in overdrive, you just tap the gas and you've got power. I can't wait
until
> I can really get on the gas.
>
> I'm breaking them in over the next couple of days and then going on the
dyno
> on Saturday for some non-blower numbers.
>
> On a side note, when I went to pick up the truck, the owner told me there
was
> one problem. When they were taking the truck off the lift, one of his
> employees managed to put a pretty good dent in one of my nerf bars. So,
he
> ordered me a brand new set! I'm picking them up tomorrow. Now that's
> customer service. He didn't wait for me to notice and complain, he just
took
> care of it.
>
> By the butt dyno, gears seem to be the best bang for the buck of any mod
I've
> done. And I've done a few.
>
> Bill White - http://www.moparforme.com
>
> THE BIONIC DODGE - 2000 Ram QC 1500 Sport, 408 Stroker - All Motor &
Staying
> That Way
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:51 EDT